All of the free patterns and tutorials on this website are supported by my amazing Patreons! If it wasn't for them I wouldn't be able to continue to produce or host freebies. We'd love to have you join us and in return, you get exclusive behind-the-scenes material, member-only discounts and early access to new free content. Membership starts at $1 per month. If you'd like to, you can say thanks for the freebie via the Tip Jar.

Description

Bridget is a square top Hat with wide vertical ribs around the entire beanie. The brim is worked in pattern and is folded up, so that the ribs on the brim alternate with the ribs on the body of the Hat. There is a large pompom added to each corner of the crown.

Availability

My Patreon supporters and members of The Woolly Hat Society get exclusive early access to new free patterns and tutorials. Once the exclusive period is over it’s published here on the blog.

Support

If you have a question about this pattern, pop it in a comment below. Sorry, but I’m unable to help with my free patterns or tutorials via email or private messages.

Social Media

Share your hand-knit Hats online with these hashtags!

#WoollyWormhead

#WWHats

#WWBridgetHat

Yarn
174yd/160m/100g
Chunky weight, multi-plied yarn.

Needles & Notions
Set 5mm/UK6/US8 DPNs/Circular or size needed to obtain gauge
Stitch marker as necessary
Tapestry needle

Sample details
Wensleydale Aran [174yd/160m per 100g; 100% Wool]

King Cole Merino Blend DK [123yd/112m per 50g; 100% Merino]

Note: Hat is worked with both yarns worked together throughout.

Gauge
16 sts x 20 rows to 4in/10cm on 5mm needles over St.St.

Sizes
To fit sizes: 17 [20, 22] in/43 [51, 56] cm
Finished size: 15 [17.5, 20] in/38 [44.5, 50.5] cm
Not sure which size to make? Check my handy size and measuring guide!

Skills required
Stocking Stitch

Knitting in the round

Cable Cast-on

Crochet Bind-off

3-Needle Bind-off

Stocking Stitch Kitchener

Abbreviations

K: knit

P: purl

rpt: repeat

Rnd(s): rounds

st(s): stitch(es)

How to

The two yarns are held together throughout. Alternatively, a single yarn that provides the same gauge can be used.

Cast on 60 [70, 80] sts

Join in the round, being careful not to twist stitches. Place stitch marker to indicate start of round.

Body

Rnd 1: *K5, P5; repeat from * to end

This round forms the pattern for the body. Work in pattern until the Hat measures approximately 8 [8.5, 9] in/20 [21.5, 23] cm (or desired length).

Crown

Divide stitches evenly in half and perform either a 3-needle bind off, kitchener stitch or a crochet bind off. Alternatively, cast off and seam along top.

Pompoms

The pompoms in the photo shown were made on a 3” diameter template.

Try to avoid over filling the pompom, as this would make them very heavy and likely to drag the top of the Hat down, or worse still, break off.

Instead of pompoms you could add tassels, I-cords, buttons, bells or any other kind of decoration!

Finishing

Weave in all ends. A gentle wash and blocking is recommended.